| Author |
 Topic  |
|
|
Marky
Belgium
22 Posts |
 Posted - Nov 30 2007 : 03:52:31
|
Hello Nigel,
I think I found a problem with the new MLK7 version.
I have different mailing lists that also need different "from" and "reply addresses". In the previous versons I used the option "Use a different configuration for each mailing list database".
This worked great until I upgraded to the last Business version.
This option is still selected but every time I change the "from" and "reply addresses" in a mailing list, the same settings are used when I load another mailing list. Very annoying...
I hope this can be corrected soon.
Best Regards,
Mark |
|
|
xequte
7042 Posts |
Posted - Nov 30 2007 : 22:31:21
|
Hmmm, that's not good.
I assume that is happening to all settings you change?
Can you display the main window of MLK and click Ctrl+Shift+I. What folder is displayed as your settings folder?
Nigel
Xequte Software
nigel@xequte.com |
 |
|
|
Marky
Belgium
22 Posts |
Posted - Dec 03 2007 : 01:20:16
|
Hello Nigel,
This is a screenprint:
Mainly I use 2 databases (ENDUSERS + DEALERS) with different settings.
This is the display while clicking Ctrl+Shift+I when the ENDUSER database is loaded:
This is the display while clicking Ctrl+Shift+I when the DEALER database is loaded:
All files are located on drive N: which is a mapped network drive. (harddrive connected to our network via ethernet)
Best Regards,
Mark |
|
|
|
xequte
7042 Posts |
|
|
Marky
Belgium
22 Posts |
Posted - Dec 04 2007 : 01:48:07
|
Hello Nigel,
I double checked again and the reply address stays at "DEALERS@mycompany.com" while it should be "ENDUSERS@mycompany.com" since the ENDUSER database is open now.
Also the "To Address" does not change when I load a new database.
However I think that the correct "config files" are loaded since I have different "ISP Sending limits" settings for both databases.
Before I always used these 2 databases with different settings without any problem. I only updated the software, not the settings. I also double checked again to see if the 2 databases have different setting. See the proof below:
Best Regards,
Mark |
|
|
|
xequte
7042 Posts |
|
|
Marky
Belgium
22 Posts |
Posted - Dec 14 2007 : 07:36:03
|
Solved with the 7.01 version, thanks.
However with Ver 7.01 I have another (new) problem, I will open a new topic for this.
Best Regards,
Mark |
|
|
| |
Topic |
|
Different configuration option doesn't work?
